When you’re planning to replace the distributor on a Honda Accord, it is actually necessary to know the model 12 months and engine measurement because Honda changed the procedure frequently. From 2003 onward, the Accord has had distributorless programs, however from 2000 to 2002, all Honda Accords had distributors. In 1999 and earlier, the Accord had both distributor and distributorless systems.

1996-2000 Honda Accord 2.2L and 2.3L Engines Distributor Removal and Installation Instructions

1. Search for the distributor on the engine block; it will have cables from the spark plugs leading to it. Be aware the radio code for theft protection earlier than disconnecting the negative cable to the battery.
2. Get to the crankshaft pulley bolt from the inside fender liner on the left. Use a socket, long extension piece and a ratchet to rotate your engine counterclockwise. The white Top Lifeless Center (TDC) mark on the pulley must line up with the pointer mark on the engine cover. Put a label on every ignition wire; don’t take away them.
3. Take off the distributor cap and take a look at the ignition rotor. Make certain it’s pointing toward the distributor cap terminal for cylinder No. 1. If not, use the socket and long extension deal with (breaker bar) to rotate the crankshaft one flip counterclockwise to line up the TDC mark with the pointer on the engine cover.
4. Make a mark to line up the distributor housing and the cylinder head, in addition to a mark for the rotor on the distributor housing. These have to be in line once you put in the distributor.
5. Disconnect electrical connectors on the distributor’s aspect with a screwdriver. Take out the three distributor mounting bolts with a wrench or ratchet and elevate out the distributor.
6. Set up a new, greased O-ring on the distributor shaft and put the brand new Honda Accord distributor within the cylinder head, making sure the marks you made line up. The O-ring and distributor are separate purchases. The distributor part number differs in keeping with producer and store, however ask for 83677N at Parts Train.
7. Hand-tighten the mounting bolts and replace the screws within the electrical connectors on the distributor’s side. Reattach the negative cable to the battery.
8. Reset the Powertrain Control Module idle reminiscence by beginning the engine. Preserve it at 3,000 rpm until the fan comes on, then idle 5 minutes. Hold accessories off and the vehicle in neutral or park. Put in the radio security code.